- Joined
- May 28, 2013
- Messages
- 1,982
Finally got my longer travel shocks to go with my Duff Radius Arms but now I have a clearance problem between the frame mounted track bar bracket and bolt interfering with coil cups. See pics with contact points.
The track bar bracket is large and I think stock on 76/77s.
I thought I might be able to screw in the heim joint on the rear of the radius arms to draw the axle back some but they are all the way in.
I can think of the following options:
Grind down the track bar bracket and take a small section of the coil cup out but don't like that idea too much.
Drill a new hole in the track bar bracket and raise it up, then cut the lower section off, but this would require a track bar riser on the other end. Would this require me going tie rod over to maintain the geometry OR is it okay as long as the drag link and track bar remain parallel? This should work but this thing drives great and concerned with opening a can of worms.
Any other ideas and or thoughts on these?
Thanks!
The track bar bracket is large and I think stock on 76/77s.
I thought I might be able to screw in the heim joint on the rear of the radius arms to draw the axle back some but they are all the way in.
I can think of the following options:
Grind down the track bar bracket and take a small section of the coil cup out but don't like that idea too much.
Drill a new hole in the track bar bracket and raise it up, then cut the lower section off, but this would require a track bar riser on the other end. Would this require me going tie rod over to maintain the geometry OR is it okay as long as the drag link and track bar remain parallel? This should work but this thing drives great and concerned with opening a can of worms.
Any other ideas and or thoughts on these?
Thanks!











