• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Advice on plugging firewall holes.

Acknud

Jr. Member
Joined
Mar 25, 2004
Messages
80
Loc.
Morganfield, Ky
I need some advice on plugging firewall holes. I installed a Centech harness in my '69 and had to get a little creative in the layout. I need to plug existing holes that I didn't use as well as seal around wires coming out of the opening I did use. Also, I replaced my drivers side air vent box with a toolbox conversion. This left the vent hole in the firewall so I need to plug that. Any suggestions?
 

RPM289

Sr. Member
Joined
Jan 4, 2008
Messages
835
Small holes I use large area fender washers and pop rivets, could use bolt and nut also. for bigger holes I cut patch from sheetmetal or aluminum as its easier to form to body then attach it and seam seal it around edges. I have see some cut patch panel and weld it in and grind smooth but too much work for me :)


Welcome to the group!!!
 
OP
OP
Acknud

Acknud

Jr. Member
Joined
Mar 25, 2004
Messages
80
Loc.
Morganfield, Ky
too much work for me :)


Welcome to the group!!!

Thanks. I am looking for simple but effective. Just want to keep the wind out. Thanks for the welcome. I've been a member for some time. I just haven't been on here in forever!
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
For the harness Daystar makes a cool grommet/boot. You open the end enough for the wiring and zip tie it up to seal it when done. Used a couple and like them.
 

BronCowie

Contributor
Old Timer
Joined
Apr 24, 2007
Messages
8,290
Loc.
Vancouver, WA
As an electrician, these are easy to come by for me... outdoor electrical enclosure hole seals.
 

Attachments

  • IMAG1128.jpg
    IMAG1128.jpg
    60.7 KB · Views: 194
  • IMAG1126.jpg
    IMAG1126.jpg
    65.4 KB · Views: 185

STalon89

Full Member
Joined
Oct 15, 2016
Messages
311
Measure the holes you need filled and just search for plugs on amazon. Theres tons out there, and they sit nice and tight.
 

Pa PITT

Contributor
Bronco Guru
Joined
Jul 15, 2005
Messages
11,300
Loc.
Stephenville TEXAS
STALONG89. I agree with his statement .. They make plastic ones that you can push into the holes. & There are lots of rubber ones. I put a lot of Plastic ones in my dash. & Then I sprayed over mine with Under coating. & I even have one I covered with a NO.16 can lid & then undercoated over both sides of it.
Welcome.
 
Top