• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

info for EFI ?

roundhouse

Bronco Guru
Joined
Sep 5, 2003
Messages
2,956
I know this has been covered before , but im evidently terrible at searching.

I have an acquaintance thats looking to install an efi 5.0 in his 49 Ford pickup,

I suggested a pre 2002 2wd explorer, since he could use the engine trans and rear axle, but some one else that he talked to said that was too difficult because of the traction control, abs, passkey, etc etc.
and said the Lincoln Mark 8 was the easiest swap.

I think he bought a 87 F-150 to use for the transplant.

I did my efi using a 91 mustang in 1999, so I am unfamiliar with all that.

the fordfuelinjection.com site is gone.?
so I m not sure where to send this guy for solid info.

I thought everyone either had all that deleted from the computer or just used a older A9P computer?
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,651
Yes, all that extra stuff is deleted, or codes thrown are ignored, for swapping into an older truck. I agree the Explorer is the best, but for a vehicle like your friend's it's not as required because they have more room under the hood than we do with the Broncos.
I don't think the Lincoln would be any easier as they had their own extras as well.

The F150 would be a great donor I think. Not for us of course, with our lack of hood clearance. But for their '49 Ford? Probably a sweet install. And a 351 would be even better!
Both the Lincoln and the '87 302 could be Speed Density vs the more desirable Mass-Air of the Mustang and later Explorer. The trucks went to Mass-Air on the 351's and probably even the 302's finally, but not until about '95/'96 when OBD-II was coming into play. But pretty sure lots of the 302's were Mass-Air earlier on. Maybe his '87 already is?
A factory speed-density engine will run fine, but does not take as well to modifications. An aftermarket speed-density computer that can be tuned is just fine however.
You can use the A9P (automatic trans) and A9L (manual trans) computers with the harness up to '94 engines, but you need to make sure all the sensors are keyed to the harness and such. The later ECM's used different main harness connections too, so an early harness is not compatible with a later computer. Explorers used disstributorless ignition too, but that's also a good thing if you take a little extra care in putting it all together.

And Ryan's old information is still available because virtually everything that ever was or will be on the internet is archived on the servers. I forget how to search for it, but I believe you put "archive" in front of your search criteria and it's all there.
Someone posted a link to it just the other day and I didn't bother paying attention and saving it like I should have. You might find it through a google search using "site: classicbroncos.com" ahead of your search terms. Either "fordfuelinjection.com" or the later "oldfuelinjection.com" when Ford went after Ryan for using ford in the name. Too bad too, because it's not like he was stepping on toes and making product with ford logos on it and such. Just promoting better information sharing.

Good luck. Let us know how your friend's project comes out. Is he over on fordtruckenthusiasts.com forums?

Paul
The
 

BroncoChicken

Sr. Member
Joined
Mar 29, 2015
Messages
359
I know this has been covered before , but im evidently terrible at searching.

I have an acquaintance thats looking to install an efi 5.0 in his 49 Ford pickup,

I suggested a pre 2002 2wd explorer, since he could use the engine trans and rear axle, but some one else that he talked to said that was too difficult because of the traction control, abs, passkey, etc etc.
and said the Lincoln Mark 8 was the easiest swap.

I think he bought a 87 F-150 to use for the transplant.

I did my efi using a 91 mustang in 1999, so I am unfamiliar with all that.

the fordfuelinjection.com site is gone.?
so I m not sure where to send this guy for solid info.

I thought everyone either had all that deleted from the computer or just used a older A9P computer?

EFIGUY can turn off the traction control/abs/etc features in the Explorer computer. I would encourage them to go this route
 

spap

Bronco Guru
Joined
Jan 2, 2010
Messages
2,642
The motor most like the mustang engine is the Lincoln mark vii 5.0 ho 225 hp but only speed density no mass air. The Lincoln mark viii is a whole different animal 4.6 dual over head cam s 295 hp etc
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
It was tough not breaking those 80's electrical plugs 15 years ago. That 87 harness is likely to just crumble as he tries to remove it. Engine is speed density and flat tappet cam. Won't accept upgrades. Transmission is likely just an AOD. Boring nothing special and a lot of work to make it boring.
 

Jdgephar

Bronco Guru
Joined
Sep 25, 2012
Messages
1,526
the fordfuelinjection.com site is gone.?

so I m not sure where to send this guy for solid info.



I thought everyone either had all that deleted from the computer or just used a older A9P computer?

I saved all the data from the site. PM your email and I can send it.

Sent from my SM-G981U using Tapatalk
 
OP
OP
R

roundhouse

Bronco Guru
Joined
Sep 5, 2003
Messages
2,956
It was tough not breaking those 80's electrical plugs 15 years ago. That 87 harness is likely to just crumble as he tries to remove it. Engine is speed density and flat tappet cam. Won't accept upgrades. Transmission is likely just an AOD. Boring nothing special and a lot of work to make it boring.

He keeps sending me ads for engines for me to look at, engines that are no longer in the vehicle.
“The ad says It runs good and the trans is good “

My response is always : “ if you can’t hear it run, just assume it’s junk and will need a full rebuild “
In keep telling him that he needs to buy a drivable vehicle so he can test the engine and trans , drive it home and sell off the un needed parts after he is done.
That every time I’ve bought an engine that I can’t test drive, I’ve gotten ripped off.
 
Top