- Joined
- Nov 3, 2003
- Messages
- 51,650
Post up your page of the Centech instructions that I saw earlier. That will help to, I think, essentially, do what was said. Except I didn’t realize there were two purple wires coming out of the driver side.
So you don’t need to cut the start NS wire and splice it into the neutral safety switch. That was with a different generation Centech harness.
This one changed so that you have one wire marked “start” coming out of the driver side, that goes to one side of the NSS.
You have another purple wire coming out of the driver side that says “start NS” and that goes to the other side of the neutral safety switch.
Then on the passenger side, safely tape up the end of the purple wire marked “start” and tuck it away.
Only the wire marked “start NS” attaches to the S post of the starter relay.
Done.
So you don’t need to cut the start NS wire and splice it into the neutral safety switch. That was with a different generation Centech harness.
This one changed so that you have one wire marked “start” coming out of the driver side, that goes to one side of the NSS.
You have another purple wire coming out of the driver side that says “start NS” and that goes to the other side of the neutral safety switch.
Then on the passenger side, safely tape up the end of the purple wire marked “start” and tuck it away.
Only the wire marked “start NS” attaches to the S post of the starter relay.
Done.











