Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
If you have problems registering or can't log into your account, please contact Admin.
Pulled the pinion on my 4:11 rear to replace seal and third member is broken where pilot bearing seats. Will any third member work and swap my gears into it?
Any 9" case will work, but I would spend the $200-300 (4-5 choices in that range for a nodular case)...and have your gears installed in it. I wnet with the Strange Pro-case...very beefy (~315 via Summit)...but they (Strange) offer an option for $230 as well...as a side note all the Strange stuff is cast and machined here in the US. The Yukon cases are not.
This wasn't in my budget, but gets me doing one more thing I haven't done. Going to look at a 9" in the morning that may already have 4:11's in it for $100. Just wanted to make sure the third member would work. I know something changes with gear sizes. Is it just the carrier, not the third member? Really don't have a clue about the inner workings.
With the 9" there is no difference for different gearing. That is the D44 - which splits at 3.90. Installing gears in a 9" is really easy, all you need is a dial-indicator and a couple torque wrenchs.
This wasn't in my budget, but gets me doing one more thing I haven't done. Going to look at a 9" in the morning that may already have 4:11's in it for $100. Just wanted to make sure the third member would work. I know something changes with gear sizes. Is it just the carrier, not the third member? Really don't have a clue about the inner workings.
X2 main differance will be axle spline count. really only broncos, some cars, early 1/2ton trucks and vans got 28 spline axles. in the 70's pretty much only broncos and some vans had 28 spline axles so most 3rd members will be 31 spline. but for the most part you can use your gears and carrier in any third member there were some early 3rd members that use bigger bearings and there are factory nodular 3rd memebers that may also take larger bearings in either case you should be able to get conversion bearings to fit if needed.
Thanks again guy's. Think I got it now. Glad to hear I hadn't completly lost my mind. I knew there was a change point on gearing somewhere, I confused the front with the rear. Worst case I can use the guts out of mine. Is a used third member worth $100?
Picked up the rear end for $100 and is already has 4:11's. Susposed to be 28 spline so good to go. Even if it's 31 spline, I'll upgrade the axels. Special thanks to broncnaz. The guy had an NP435 hooked to a Dana 21 and broncnaz advised me it would work. It is 28 spline output and looks like everything will fit perfectly. $125, couldn't pass it up. Impossible to find locally. Thanks guy's.