MonsterBIlly
Sr. Member
- Joined
- Dec 17, 2015
- Messages
- 461
So I am on my 4th trans in 4 years. I have had the same shop rebuild it twice and warranty it once. So this time I ordered a new one from Monster Transmission. Their were great to work with, their customer service is awesome and they keep you constantly updated. However!
I had made the order over the phone. I gave them all the info as was very specific. The trans snowed up today and something seemed off. And it was. they sent me a 97 model rather than the 98-2003 I had specified. There are only a couple diffs. Mainly the shift solenoid plug is different, 7pin rather than a 9 pin. This can be corrected easy with a slight rewire or a partial harness from US shift. The other though is the length of the output shaft. The 97 shaft is 1 inch too long. It wont fit let the atlas contact the trans. the size and spline count are the same. Can I just cut the shaft 1 inch? if so what is the best way just us a grinder or gig up a chop saw.
I take partial blame, I should have looked over the invoice in detail and didn't. John at Monster was so thorough and even repeated the year (98) to me over the phone. I know by now not to assume anything but I did.
I did email them and I'm sure I will hear from them tomorrow
I'm so over this transmission shit. It almost make me want to sell it and be done. However I wont. I'm just venting... again.
I had made the order over the phone. I gave them all the info as was very specific. The trans snowed up today and something seemed off. And it was. they sent me a 97 model rather than the 98-2003 I had specified. There are only a couple diffs. Mainly the shift solenoid plug is different, 7pin rather than a 9 pin. This can be corrected easy with a slight rewire or a partial harness from US shift. The other though is the length of the output shaft. The 97 shaft is 1 inch too long. It wont fit let the atlas contact the trans. the size and spline count are the same. Can I just cut the shaft 1 inch? if so what is the best way just us a grinder or gig up a chop saw.
I take partial blame, I should have looked over the invoice in detail and didn't. John at Monster was so thorough and even repeated the year (98) to me over the phone. I know by now not to assume anything but I did.
I did email them and I'm sure I will hear from them tomorrow
I'm so over this transmission shit. It almost make me want to sell it and be done. However I wont. I'm just venting... again.











