I have one hell of a list....
The best one was CB antenna holes in the hardtop....both sides...which were patched with roofing tar, aluminum foil, and round electrical plates.
The PO didn't know jack about installing the 351W, so instead of putting on the 302 waterpump, he took the radiator out and had the ports switched to opposite sides...%)
Now, because he switched the ports on the radiator, the bolts for the power steering box were in the way....so he took a big hammer, and did everything he could to destroy the frame where the PS box bolts on.
I don't think there was a single tight bolt or nut anywhere in the steering system.
Fancy wood dash...with a nice big hole for something like a stereo...promptly ripped out.
Of course, the usual hack job for the shifter.
Nice, big, slice-your-hand-open hole in the hood, with a spiffy trans am hood scoop rivited in place over it...you know, the ones with the ridge running down the center.
he ruined the body by hanging a 33" tire in the stock rear tire carrier....Just FYI for those that don't get it....that tire carrier bolts to your body, and should never have that much weight on it...you get what I have, Bronco 'body' lean. The whole corner of the truck is about 1/2-1" out of wack.
I think I could make the list longer....but that's all I remember off the top of my head.
OOOO....one more! he cut the brackets off the rear seat, had some 1/2 inch plate aluminum wheel stops fabbed up, and used those as new "brackets" for the rear seat.
Mrcat88
I don't the PO knew what wiring was....I think it was like "hey, if it sparks, I'll get power out of it!"
Repairs? What repairs? I don't think my truck has ever seen repairs!