Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
If you have problems registering or can't log into your account, please contact Admin.
Taking my fuel pump eccentric off for an Explorer Serp conversion and I started to wonder about the cam dowel pin - is it too deep? Should I be concerned? Or am I over-reacting, cause I never do that, Oh My God, I Never Over-react!;D
Not overthinking at all. A good call I would say.
I can't verify 100% but I'm pretty sure that you do in fact have to shave it down some for clearance under the new cover.
Someone will let you know, but at a guess I would say that as long as it engages the gear without sticking proud of it, you'd be good to go.
What about the gears and chain themselves? Are they from the engine, or are they Explorer spec?
Not sure there's a difference, but if we're going to overthink things, why not go all out!
What about the gears and chain themselves? Are they from the engine, or are they Explorer spec?
Not sure there's a difference, but if we're going to overthink things, why not go all out!
The pin is in shear. Just made sure you always have the pin crossing between the cam and overlapping the gear and you are fine. Maybe 1/2 the pin diameter or more of overlap would be fine.
There is a great joke in there, but I am going to leave the low fruit hanging! Thanks for the response I agree (didn't even think about the pin being a short pin) with your assumption - makes total sense!