• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Engine angle

77broncodriver

Full Member
Joined
Nov 21, 2009
Messages
344
I am in the process of installing a 4r70 and have it in there bolted to the engine and have a zf crossmember but have to make a piece to connect the Trans to the crossmember. Now the question is, I jacked up the transfercase and Trans to where the front yoke clears the x member. Where it looks good the engine is angled back at about 5. Is that okay? Or is it suppose to be flat? I can make it flat and that gives me better ground clearance but I don't want to mess up the rear driveshaft angle.

Hope that made sense, I'm writing this on my phone, thanks, Evan
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
It is angled. Forget the exact angle.
Too low and the heads are into the firewall.
Forgot what too high is.
 
Top