77broncodriver
Full Member
- Joined
- Nov 21, 2009
- Messages
- 344
I am in the process of installing a 4r70 and have it in there bolted to the engine and have a zf crossmember but have to make a piece to connect the Trans to the crossmember. Now the question is, I jacked up the transfercase and Trans to where the front yoke clears the x member. Where it looks good the engine is angled back at about 5. Is that okay? Or is it suppose to be flat? I can make it flat and that gives me better ground clearance but I don't want to mess up the rear driveshaft angle.
Hope that made sense, I'm writing this on my phone, thanks, Evan
Hope that made sense, I'm writing this on my phone, thanks, Evan











