• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Instrument gauges

rfebronco

New Member
Joined
May 25, 2007
Messages
32
Trying to problem solve an issue. Gauges all stop working except alternator gauge. I replace the instrument voltage regulator. Did not fix the issue, also the problem drains the battery even when the keys are out and everything off. Any ideas?
 

B RON CO

Contributor
Bronco Guru
Joined
Jun 29, 2016
Messages
2,484
Loc.
Statesville, NC
Hi, if you are testing the gauges with the instrument panel put it may not be grounded. You can test for @ 6 volts pulsing at all the gauges and all the sender wire ends. As you know the Amp gauge is not connected to the other 3. The gauge circuit should be off when the key is off. The battery drain may not be related. Did you try pulling fuses to isolate the short? Good luck
 

EPB72

Contributor
Bronco Guru
Joined
Jul 13, 2019
Messages
1,216
Loc.
Pleasant Hill, CA
What B ron C said,,,,
about the battery going dead is the battery fully charged and has it been tested??

Has the charging system been tested ??

Now for the parasitic draw.. do you have a multimeter with amps range?? if not a test light will do get old sckool incandesent bulb test light ,,disconnect one of the battery cables from the battery post ,,clamp test light lead to battery post and then the light probe end connect/wedge in the cable end of battery cable you disconnected..at this point if the test light is lit up then you have a draw depending on brightness minimum would be about 350 milliamps as that is what the bulb will take to light up...

so if the light is on you can start unplugging stuff till the light goes out,,such as voltage regulator for charging system,, fuses one at time ,aftermarket radio? other after market add ons...disconnect one at at time and check the light..if you have a amp meter you can do the same kind of set up at battery but you would know the exact amount of your draw,, But again you should have a fully charged good battery..
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
Did you check if you have 12V going into the IVR? The old one may not be bad if it simply didn't have power in the first place.

And probably completely unrelated to a parasitic draw on the battery.
Does the battery hold a charge overnight if you leave it disconnected? If not, the draw is internal to the battery.
 
Top