behemoth
Bronco Guru
- Joined
- Jul 2, 2003
- Messages
- 1,736
I have thought about the cage-rollbar but I can not see one that does not break up the lines. If I was to do anything it would probably be chrome and very small. With the height required ( basically the height of the windshield) it would really stand out. As low as mine sits I can not see a roll over unless some extreme failure happens.
Aparently mine sits lower than Dales does as I had to deal with the inner fenders could be the height as well as my moving the front axle forward a bit.
With the width of the front suspension the tires sit far enough in to clear the fenders when turning. I will have to roll mine and I knew this going in.
Looking back I would probably not drop it this far, but were only speaking an inch at most.
The harness I used is the one I took from the mustang and sent it to Kolibar to have it done.
What measurements do you want from my truck, front fender lip to wheel center ?
Aparently mine sits lower than Dales does as I had to deal with the inner fenders could be the height as well as my moving the front axle forward a bit.
With the width of the front suspension the tires sit far enough in to clear the fenders when turning. I will have to roll mine and I knew this going in.
Looking back I would probably not drop it this far, but were only speaking an inch at most.
The harness I used is the one I took from the mustang and sent it to Kolibar to have it done.
What measurements do you want from my truck, front fender lip to wheel center ?











