• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Major EFI problems

chuzie

Bronco Guru
Joined
Jul 21, 2006
Messages
2,761
The Mustang community has always been a huge help to me in the past and I find this NO START CHECKLIST particularly helpful. Keep in mind you some interpretation is required considering our harnesses and connectors and other variables may be different but the basic info in still relevant.

www.stangnet.com/mustang-forums/thr...-checklist-for-fuel-injected-mustangs.787471/

My Ford service manual points to Dizzy, TPS, or EEC. I attached the 97 Service manual section on the TFI. It is still applicable to your year of stuff. I tried to upload my EEC diagnostic manual as well but was 1,054Kb which is slightly over the limit but I will be happy to email it to you.
 

Attachments

  • ignition system tfi iv.pdf
    266.1 KB · Views: 942
OP
OP
77broncodriver

77broncodriver

Full Member
Joined
Nov 21, 2009
Messages
344
im back at it today. i checked to make sure the ect is working and it is working properly. next i checked for spark when it stalls when its been idling for a while, i get spark out of the coil. then i disconnected the spout but it didnt help still wouldnt start. then i went to start it about 20 min later and it would start with the spout plugged in. let it idle for half hour then it died, wouldnt restat but then without the spout plugged in it started up again. im now waiting for it to die again to test, im not what im testing next yet.
 
OP
OP
77broncodriver

77broncodriver

Full Member
Joined
Nov 21, 2009
Messages
344
decided to drive it up the street and then it died, luckily im at the bottom of a hill so rolled back, i have spark at the coil and pretty sure i have power at the fuel pump, i hear it purge when before i start it and i have fuel pressure. so is it possible something in the dizzy is going off and on?
 
OP
OP
77broncodriver

77broncodriver

Full Member
Joined
Nov 21, 2009
Messages
344
i just checked the ect when it wont start and its at 1.1v so its reading the temp is about 150f, my mechanical gauge says its at 180f is this far enough off for it not to start?
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,651
Wouldn't think so, but wait for someone who knows for sure.

Did you ever say whether or not you were using thermal paste on the back of the TFI modules? I know you said you tried different ones (3 of them?) but it sure acts like an overheating module. Right down to the restarting and running when things cool down.

Paul
 
OP
OP
77broncodriver

77broncodriver

Full Member
Joined
Nov 21, 2009
Messages
344
im not exactly sure if it was thermal paste but it was the stuff that came with the tfi so i assume its the right stuff. to me it seems like its the tfi or something in the dizzy. when i get back for spring break in a couple weeks im probably just going to replace the dizzy with a new one and they come with new tfi sensors on them too.

This thing will be driving sooner or later! i think after i get the stalling fixed it needs to get tuned to make it run as it really should.

Evan
 

WheelHorse

Bronco Guru
Joined
Nov 22, 2004
Messages
2,511
When this thing stalls, pull a plug and see if it's wet or dry.
Reinstall.
Crank it for 5 seconds...check plug again

IF everything is working, after 5 seconds of cranking the plug should be wet if you have fuel.

Also you said you have spark at the coil, did you bring an extra plug and see if you have an arc at the plug wire end?
 
OP
OP
77broncodriver

77broncodriver

Full Member
Joined
Nov 21, 2009
Messages
344
I didnt get to check to see if i had spark at the spark plug get, it cooled down and started.
I will check al this, thanks for the info.

Evan
 
OP
OP
77broncodriver

77broncodriver

Full Member
Joined
Nov 21, 2009
Messages
344
Im getting pretty sure its the tfi that keeps going out, my engine bay gets pretty hot, im guessing a lot hotter than a stock mustang.

I found this tfi relocation kit, comes with the wiring and the block it sits in to cool it down. im going to mount it somewhere where i get a lot of air, maybe even try to get it behind the dash somewhere if its long enough away from the heat.
http://www.mccullyracingmotors.com/index_files/tfikits.htm

then get a new stock dizzy with tfi and put it all together from autozone.
 
OP
OP
77broncodriver

77broncodriver

Full Member
Joined
Nov 21, 2009
Messages
344
I hope this thread hasnt got too confusing but i got a new dizzy and a remote tfi with new module.

i havent driven it yet but it seems like its running better, i have one more question.

my fuel pressure it as 46ish when i give it gas, that seems a little high. is the stock pressure regulator on the back of the fuel rail adjustable? if so how do i adjust it, if not what type should i get?

Thanks Evan
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
No the stock regulator isn't adjustable. You may have some restriction in the return line. "When I give it gas" is meaningless. What is it at idle with the vac connected and disconnected?
 

70_Steve

Old Guy
Joined
Dec 13, 2002
Messages
8,317
my fuel pressure it as 46ish when i give it gas, that seems a little high. is the stock pressure regulator on the back of the fuel rail adjustable? if so how do i adjust it, if not what type should i get?
That vacuum line changes the fuel rail pressure as the manifold vacuum changes. You should see 39 psi with the vacuum line disconnected.
 
Top