• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Pro Flo 4 EFI

ChrisC74

Sr. Member
Joined
Dec 9, 2010
Messages
906
If you are running a Edelbrock Pro Flo 4 EFI can you please let me know what in tank pump you are running and if you are using an external regulator.

I am considering switching from a Fitech to the Pro Flo and currently have an Aeromotive 11540, 340 stealth series high flow pump and use the internal regulator and return line.

Additional information, I have run the Fitech for years, have had had a professional check the install, had several knowledgeable folks help tune it and for the most part it runs very well. There are still a couple of annoying issues I cannot seen to tune around and have need intrigued by the Pro Flo for a while so I am going to give it a try.

I ran the same Fitech on my second bronco, similar engine, same pump, etc and it ran spot on. So it very well could be a hardware issue but it is years old and out of warranty so it is time to try a newer system.

Thx.

Sent from my SM-G970U using Tapatalk
 

BtheFelix

New Member
Joined
Apr 8, 2017
Messages
14
I just finished installing my PF4. Absolutely love it. The PF4 can directly power low-amp pumps without a relay. I’m currently running an external Walbro GSL392 pump mounted near the rear tank and a return line. I’m using the Edelbrock 1728 regulator mounted o. The firewall. You might want to look into the Edelbrock 17400 or 17401 regulators, they mount to the fuel rail which is nice but are not adjustable.

Bryan


Sent from my iPhone using Tapatalk
 

PDQ

Contributor
Full Member
Joined
May 6, 2012
Messages
297
Bryan, did it fit under the stock hood? And/ or what air filter are you running for clearance?

Thanks
 
OP
OP
ChrisC74

ChrisC74

Sr. Member
Joined
Dec 9, 2010
Messages
906
Bryan, did it fit under the stock hood? And/ or what air filter are you running for clearance?

Thanks
Great question! I have a 1" body lift and am hoping that is enough. I understand it is a net 3/4" higher than the fitech I am running.

Sent from my SM-G970U using Tapatalk
 

BtheFelix

New Member
Joined
Apr 8, 2017
Messages
14
I have the Edelbrock 1223 filter which is a 14” diameter x 3” tall filter element. It clears my stock style hood by a good 2”. I should be receiving a 4” tall K&N element today. I’m running a 3” body lift (40” tires).

The real number you need to know is the top of the throttle body is 9” from the top of the block on a 351W. This was less than the carb’d setup I was running before.
 
Top