I have an Actron CP9145 OBDII scan tool for newer vehicles. I saw that there is an adapter harness so it can read Ford OBD1 codes, so I bought the adapter harness. I got tired of counting blinks.
Has anyone else used this setup? I can't get it into test mode with KOEO test. With the Actron harness hooked to the EEC test port, and turn the key to on position, the scan tool just says something to the effect of "you must hook the tool to the vehicle to read codes," which I did.
I know with the light blinks counting, doesn't the ground from the single test plug put the computer into code reading mode. When I turn the key on, & with the scan tool hooked up I'm only hearing the 2sec prime of the fuel pump....not the usual clicks and cycling of relays that I heard when in test mode about to read light blinks.
I'm stumped.......
Anyone have a suggestion how to get codes into the scan tool?
Thanks in advance.
Happy Thanksgiving!
Has anyone else used this setup? I can't get it into test mode with KOEO test. With the Actron harness hooked to the EEC test port, and turn the key to on position, the scan tool just says something to the effect of "you must hook the tool to the vehicle to read codes," which I did.
I know with the light blinks counting, doesn't the ground from the single test plug put the computer into code reading mode. When I turn the key on, & with the scan tool hooked up I'm only hearing the 2sec prime of the fuel pump....not the usual clicks and cycling of relays that I heard when in test mode about to read light blinks.
I'm stumped.......
Anyone have a suggestion how to get codes into the scan tool?
Thanks in advance.
Happy Thanksgiving!











