• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Reading OBD1 codes w/ Actron scan tool

mattt

Bronco Guru
Joined
Sep 23, 2006
Messages
3,814
I have an Actron CP9145 OBDII scan tool for newer vehicles. I saw that there is an adapter harness so it can read Ford OBD1 codes, so I bought the adapter harness. I got tired of counting blinks.

Has anyone else used this setup? I can't get it into test mode with KOEO test. With the Actron harness hooked to the EEC test port, and turn the key to on position, the scan tool just says something to the effect of "you must hook the tool to the vehicle to read codes," which I did.

I know with the light blinks counting, doesn't the ground from the single test plug put the computer into code reading mode. When I turn the key on, & with the scan tool hooked up I'm only hearing the 2sec prime of the fuel pump....not the usual clicks and cycling of relays that I heard when in test mode about to read light blinks.

I'm stumped.......

Anyone have a suggestion how to get codes into the scan tool?
Thanks in advance.
Happy Thanksgiving!
 

motoman

Bronco Guru
Joined
Jan 29, 2002
Messages
1,729
Loc.
Phoenix, AZ
For the ODB I you have the large plug and a single wire plug... be sure the single wire plug in plugged into the tester also along with the large plug.....
 
OP
OP
M

mattt

Bronco Guru
Joined
Sep 23, 2006
Messages
3,814
Yep, both plugged in. I'm going to go back & check the stupid stuff....like checking continuity on the test plugs from wire to spade terminal in the plug. It's acting like it's getting no ground from the single, small wire of the test circuit.
 
OP
OP
M

mattt

Bronco Guru
Joined
Sep 23, 2006
Messages
3,814
Talked to actron tech on the phone today....you must use the cig. lighter power adapter cord with this OBD1 adapter harness. That is how the scan tool grounds thru the vehicle to provide codes. I've been using the scan tool off the 9v battery.
 
OP
OP
M

mattt

Bronco Guru
Joined
Sep 23, 2006
Messages
3,814
Thanks. From my first post..."I got tired of counting blinks."
 
Top