What have you done to your Bronco today?

[okorangebrnco]

Knocked the dust and bird crap off of mine and made sure it would still start. Slowly getting some where on it

 

[Kyle.malone]

What shifter did you use? Pics?

I used the cable shifters from Atlas on the 4 speed and ran a B&M shifter. Here's some pics.

Don't mind all the crap sitting in the floorboards. It has been in pieces since Thanksgiving.

Today I finally fabbed up my crossmember. It aint pretty but it'll work.

 

[apachetech]

I started pulling the carpet out to check for rust underneath. Hopefully I'll finish it tomorrow.

 

[deadfish]

just finished bending up frt brake lines

 

[68bronc]

Just took the plasma cutter to the rear radius arm bushing brackets (I got the holes in the t-shirt to prove it!). Gonna replace with a Uni-ball set up!

 

[sprdv1]

Kids were out of school today, so I put them to work prepping Bronco parts for paint...

Nice... better that than inside on video games right.. Good job dad

 

[JefeAZ]

Just received my reproduction 74 Bronco dealer brochure from EBay

http://www.ebay.com/itm/23051057201...NX:IT&_trksid=p3984.m1439.l2649#ht_1670wt_882

 

[bronco1017]

Drove it without the top. Not bad for February in New England.

 

[tasker]

very nice Doug! prepping my calipers to install on the rear axle...

 

[Jeff76]

Slave driver LOL

Whatever it takes!

 

[Jeff76]

Nice... better that than inside on video games right.. Good job dad

You got that right! If they weren't in the shop all day they would have been in front of that XBox contraption! Truth is, they rumble and complain a bit about these work days, but they are learning a lot, and they are personalizing the project! They even come up with some good ideas. Not sayin it's any faster than doing it all myself though....

 

[twisted77]

I thought about mine!!!

Bryce

 

[KRAWLER]

Threw another beer can at mine, once again had to talk myself out of not burning it...

 

[broncokak]

Started putting the T case back together. Need to pick the case up from being cleaned tomorrow and then put all the guts back in it.

 

[Raven Tooth]

New headlight switch so now my dash lights work. Fixed my rusty, seized e-brake and tightened it up so that works too. New tires tomorrow.

 

[sriha]

Haven't seen it in a few days. Hoping to get out to the garage this weekend...

 

[xcntrk]

Installing new 3rd Member and Axles.

 

[craigaria]

Painted fender flares the other day.

Today cut down my u bolt so I could torque them and installed a new rear u joint. Seems to have helped with driveline vibrations a good bit...

 

[bigcountry]

oiled the speedo cable so maybe it will stop jumping from 20 to 100mph.

 

[tasker]

went to deadfish's garage to be humbled once again....he IS doing a great job.....