Hi All,
I'm just trying to educate myself and in the process case down a few gremlins in my Bronco. My Bronco was a 73 with a 77 front end including y linkage. I just upgraded the following...
-2.5 inch WH lift with Bilsteins
-adjustable trac bar (for a 73')
-1" Body lift
-WH Y to T steering linkage kit
-Rebuilt the steering box
-Selectable lockers (Front Yukon Zip, Rear ARB)
-4.11's
-35 Spline Axles (WH) in the original small bearing 9"
-33" BFG's Up from 31's
The right tie rod end is currently rubbing on the rim when you turn hard to the left. and I'll install a set of 1.25" spacers on the front this weekend.
Everything was aligned and the front axle centered.
Long story short, I get it back and it pulls hard to the right on acceleration. Let off the gas and it pulls back to the left. Scary as h*ll to drive as you end up in places you never intended to go. I'm just curious whether anybody has run into this issue and how you solved it?
The mechanic that did the installation thought it was a rear end issue while the gear shop insisted it had something to do with the Trac bar's mounting location. I have an appointment to take it to another alignment shop this weekend that supposedly has more experience with this problem but I'm afraid I'm a bit clueless on this one.
Any suggestions would be much appreciated.
Thanks!
Tim
I'm just trying to educate myself and in the process case down a few gremlins in my Bronco. My Bronco was a 73 with a 77 front end including y linkage. I just upgraded the following...
-2.5 inch WH lift with Bilsteins
-adjustable trac bar (for a 73')
-1" Body lift
-WH Y to T steering linkage kit
-Rebuilt the steering box
-Selectable lockers (Front Yukon Zip, Rear ARB)
-4.11's
-35 Spline Axles (WH) in the original small bearing 9"
-33" BFG's Up from 31's
The right tie rod end is currently rubbing on the rim when you turn hard to the left. and I'll install a set of 1.25" spacers on the front this weekend.
Everything was aligned and the front axle centered.
Long story short, I get it back and it pulls hard to the right on acceleration. Let off the gas and it pulls back to the left. Scary as h*ll to drive as you end up in places you never intended to go. I'm just curious whether anybody has run into this issue and how you solved it?
The mechanic that did the installation thought it was a rear end issue while the gear shop insisted it had something to do with the Trac bar's mounting location. I have an appointment to take it to another alignment shop this weekend that supposedly has more experience with this problem but I'm afraid I'm a bit clueless on this one.
Any suggestions would be much appreciated.
Thanks!
Tim











