Thanks guys for all the data, I've learned a lot here so far.. Looks like I've got positive stop studs, and when I removed the stud nut I'm thinking it had nothing like 20 ft lbs of torque on it? I measured the push rod at 6.883" and I know it has an "other that stock" cam but not sure just how aggressive.. The build sheet says a 275 Comp cam?? I do know that the rockers are Comp cam 1.6's but this truck has been full of surprises, some pleasant and some not do pleasant.. The push rod was leaned over but not rubbing the edge of the hole cast in the head.. I rolled the push rod on a very flat surface and it took off and seemed to roll very true with no wobble or humping.. I laid a machine tool straight edge across the top of both the adjacent studs and it doesn't appear to be any longer than those, but my eyes ain't what they use to be and had at least 3 different lights shinning on it at the time? When using a longer straight edge to span more studs, I get interference from the rocker arms I guess due to their position.. I'm pretty sure they are rail rockers but will post a pic shortly so maybe you guys can verify this.. The push rods are hollow so I'm assuming they are hydraulic? I'm leaning towards just pulling the other valve cover, removing the spark plugs and going through the procedure and torque the nuts to 20 ft/lbs and maybe put some blue thread locker on the studs (what could it hurt) .. Then again, maybe I should do the "Dry erase" marker method to verify push rod lengths simply so I will know what I have here regarding cam, heads, valve seats etc..? Thanks again..