Those bolts aren’t shiny enough for that truck.All back together minus fan shroud. Had a little incident. I will say it's way easier to remove in pieces than all together
Those bolts aren’t shiny enough for that truck.All back together minus fan shroud. Had a little incident. I will say it's way easier to remove in pieces than all together
Might I throw in a spot of wisdom. When I did my dash, I also had it out on a table, I went to great lengths to wire, tab, wrap everything together.Began the wiring process. Started on the dash with the Painless kit. Went with this because I wanted stock connectors, labeled wires and more accessory outlets.
![]()
![]()
![]()
![]()
Kyle
Sent from my iPhone using Tapatalk
I've found with more success than failure, break free, heat, and actually tighten the rusty bolt a little, then remove it.We all hope & pray when slowly "cracking" each wtrpump bolt that we don't hear that dreaded metallic snap... or feel the wrench go from 20ftlbs of torque to ZERO in a split second! Aaaaugh!! lol
I agree. I'm leaving most of the wiring un loomed. However it is bundle tighly with ties. I also leave some slack on each connection to switches and terminals.Might I throw in a spot of wisdom. When I did my dash, I also had it out on a table, I went to great lengths to wire, tab, wrap everything together.
Don't. An issue I am having is the bundle of wires which looks so very nice wrapped in protective covering, and taped at interval, is now so tight it can wiggle connections off the back of the radio, and dash lights. Working on that. I would only use wrap going through firewall or where you need wire protected like frame or engine bay.
Brought it home from the painter. Reassembly started....
Went to run an errand and turned the key. It cranked for a moment, and I remembered I didn't set the choke, so I cranked it again and it just clicked. The battery is in good shape, so I checked the starter connection and that was tight too. Later on, I tried it again and it started right up. Grrr... I hate these intermittent issues.
Yep. I had just gone thru everything when I pulled the starter out to wrap it. I suspect it's my solenoid of indeterminate age.Did you check for a good "clean" ground connection(s)?![]()
Might I throw in a spot of wisdom. When I did my dash, I also had it out on a table, I went to great lengths to wire, tab, wrap everything together.
Don't. An issue I am having is the bundle of wires which looks so very nice wrapped in protective covering, and taped at interval, is now so tight it can wiggle connections off the back of the radio, and dash lights. Working on that. I would only use wrap going through firewall or where you need wire protected like frame or engine bay.
I need to do this. Where did you find the template?Just installed my grill letters and used the template that Tosh had provided in this thread. From the time I printed the template, till I finished installing the letters took about an hour. Super easy this way.






