Search results

Looking to have a dana 44 setup with new guts. Any recommendations close to Austin Texas to do this for me?

I used the ones in your picture, drilled and tapped frame for mounting.

automatic? you have fluid in it?

Have you checked the fluid level?

Does it go into park if you manipulate the c4 lever at transmission by hand?

^^ what he said, I installed my new drum brakes 3 times before I figured out the support pad issue. At least now I can do my drum brakes with my eyes closed.

automatic c4

Tuning carb today, question: At idle - what rpm should i shoot for?

Good to know I didn’t want to have to drop the tank.

I noticed gas smell in garage after filling the main tank up for the first time. The leak is coming from the positive and ground pigtail prongs, not the o-ring. Is there an easy fix or do i need to drop the tank and install new sender again?

C4 FILL TUBE with B&M pan question: I just replaced my c4 fill tube with this: https://www.ebay.com/itm/fits-Ford-C4-Steel-Bell-Housing-Mount-Transmission-Dipstick-Pan/293282534425?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649#rwid I also added B&M deep pan. Question: Do I need...

Hey viper. yea I probably will move to this filter and assembly on my next transmission flush. As for starvation, you think the stock bronco filter with long pickup tube would cause this?

Just installed my B&M pan. I left the stock bronco filter on (with long pickup tube). The stock filter pickup tube has the same depth as the B&M filter. That was my thinking, I hope I am correct on this!

uggggg!! I need help Motor: blueprint 306 (bronco edition) Hey guys, looking to find a 50oz external 164 tooth flexplate for my c4 (76 bronco pan fill). Current setup not working (flexplate will not fit onto Torque converter bolts (only 2 will go through) and the plate will not allow the...

congrats on the light issue!

Ok make sure your turn signal wires coming out of steering column are not loose in the connector (plastic "horse-shoe" connector). Make sure the male "wires" not the connector are secure to corresponding wires in the other female connector. I had a new turn signal harness and the old connecter...

Reverse led light not working ???

Check voltage and orientation first on the wires coming out of stock housing and see if the 12v wire orients to the B+ on the flasher , if not do what I did

I kept stock housing and connected new wires from stock housing to flasher using spade female and male terminal ends on the wires

Me too, but I checked voltage on the wires and noticed the 12v was going to wrong terminal on my led flasher .