It's been 20 plus years since I even pulled heads. Could you give me a summary of break in failure and the rules to follow? Thanks
When assembling the cam, use assembling lube on the lifter faces and cam lobes.
Adjust the valve lash before the initial startup.
Fill the crankcase with fresh oil. Either use a high zinc break-in oil or other conventional oil mixed with your zinc additive. I use Comp Cams break in additive.
Prime the oil pump with a drill or speed handle with the distributor out to access the oil pump drive.
Have the engine ready to start and run.
Have the distributor static timed, carb primed, and coolant filled as well as possible. (have more coolant on hand)
The idea is to be able to start the engine without excessive cranking, and to come up to speed without delay.
Once fired up, immediately bring the idle up to 2000 RPM. Keep it there for at least twenty minutes.
Continue to monitor the water level and temperature, and oil pressure during this run-in.
After this initial run-in, you need to time the engine properly with a timing light and readjust the and idle speed and mixture.
I like to change the oil after the first 500 miles. I continue to use the zinc additive for the life of the motor.