• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Brake light 74' Bronco - pulling right

peaker010

New Member
Joined
Mar 20, 2006
Messages
12
Loc.
Ann Arbor
I have a bone stock 74' Bronco with a 302ci / 3 speed, drum brakes. The brake light is on and will not go off despite a full four wheel brake job. Under hard braking, the car will pull to the right as well. Any help would be appreciated.
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
You either still have some air in the system or you have a leak somewhere. After you get the pull fixed be advised that the brass brake warning switch is very prone to sticking in it's bore. I had to pull mine out, disassemble, clean, put it back together, and rebleed to shut it off.
 
OP
OP
P

peaker010

New Member
Joined
Mar 20, 2006
Messages
12
Loc.
Ann Arbor
Thanks for your quick response. Where is this brass brake warning switch? Is this the same as the proportioning valve?
 

ObscureMachine

Seatbelt Orifice Officer
Joined
Sep 28, 2006
Messages
3,998
Loc.
World Headquarters
despite a full four wheel brake job.

Just wondering, did they replace the wheel cylinders? All "full brake jobs" are not equal, sadly.

I agree with viperwolf. Did they replace the M/C? you may need to bench bleed it? Could be air in the system. Check for leaks.

Good Luck!

PS - that was the final straw for me in deciding to go to disks!:p
 

oleguy74

Contributor
Bronco Guru
Joined
Mar 26, 2008
Messages
2,034
Loc.
calif city ca
not realy same as porp.valve.mounted under master cyl on frame.baiscly just a junction block.real pain to get it centered.if brakes are bled and adj right piston will be centered and light should go out.
 
Top