• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Brake Warning Lamp

Bucky

Full Member
Joined
Aug 26, 2007
Messages
250
Loc.
New Bern, NC
I searched the old Brake Light Trends and could not find an answer to my problem. I have Disc/Drum Brakes and I'm not sure how to make the light go out. My question is with the ignition switch in the On position, and the connector disconnected from the proportioning valve should the light go out? I can not seem to crack the code on this one! I have a Painless Harness and the only way to get the light to go out with everything connected is to disconect the supply voltage from the ignition switch!

Thanks for anyone's help!!!
 
Last edited:

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,114
OK, that painless harness tosses a nasty wrench in the mix. But I will do the best I can. How it should work.
Keyed power goes to the light. Ground for the light comes from the imbalance switch (on the proportioning valve)
Unplugging the wire of the imbalance switch should turn off the light. It sounds like yours stays on. In that case the light is getting an artificial ground from somewhere. Somewhere between the bulb and that (now disconnected) connector there is a ground that needs to be removed. When you fix that then we can go back to how to center the switch to get the light out.
 

Dusty

Bronco Guru
Joined
Jun 28, 2001
Messages
2,969
I say just unhook that useless thing and use it for the check engine light on your EFI install :)

Todd Z used to say the brake warning light is great for coming on just as you're careening through the guardrail, to let you know there's something wrong with your brakes. :)

Dusty
 
Top