My 351 is getting a new top end and cam. If it turns out to need re-bore, pistons, etc., this may be a good time to do a 3.85" stroke crank. My goal is building a great TRUCK engine. This is an entirely different concept than building a race, performance, or hot rod engine. Trucks need a flexible broad power band, not high RPM power. Has anyone attempted to build a 3.85" stroke 351 that pulls from 1500-4500 RPM? The original 289-302s in my 3 EBs, made all the HP needed for off road exploring and the 65 MPH highway drive to get there. The deficiency in these engines is low RPM torque. A 351W swap was a huge improvement, so 393 CI should go further in the same direction. I use a stock C4/torque converter, 350 gears, and 31" tires. Competition Cams recommended a 198/206 degree duration hydraulic roller cam with 4 degree advance. Is this too much or too little cam? What compression ratio?
I will run a carburetor and maintain a stock engine compartment appearance, so cast iron exhaust manifolds and Ford carb. Are there any specific recommendations?
I will run a carburetor and maintain a stock engine compartment appearance, so cast iron exhaust manifolds and Ford carb. Are there any specific recommendations?











