That's a common mythconception - lowering the t-case makes BOTH d'shafts' angles better because the flex angle decreases much faster than the tilt angle increases.if you go higher in the back the angle on the front shaft gets better because of the 205 front output is pointing upward. However going up will make your rear angle worse.
I don't have the numbers for an eB, but this chart shows them for a FSB:
![]()
The TSB linked in that caption also shows how to set the d'shafts correctly on any modified vehicle.
The engine angle isn't critical - you can't set the front height - you're limited by the engine mounts & the frame perches. Just set the trans Xmbr as high as possible so you still have body clearance over the t-case.That's a common mythconception - lowering the t-case makes BOTH d'shafts' angles better because the flex angle decreases much faster than the tilt angle increases.
Steve, I'm just going to disagree with you.
Yes the engine should be tipped back a bit. If you look at the carb mounting base it is angled so the front is closer to the intake than the back. So if you mount the engine so the carb base is level you should automatically get the engine tilt u need. Look at all carbed engines. The air cleaner and top of carb are always level. But if you look at the valve covers they slant back towards the firewall
Too low and the back of the heads will mash the firewall
.
You don't have to believe either - just sketch it out in any CAD program, and rotate the engine/trans/t-case assy. so you can check the d'shaft angles for each configuration. I think we can all agree that no one would try to raise the engine through the hood, or lower it through the welded xmbr, so the pivot axis would be the line thru the engine mounts, and it would be the trans mount/bolted xmbr that would get moved.Who are you going to believe..him or your own lying eyes?;D
Not really, since it assumes the radiator angle is critical (it isn't) AND that it's mounted perfectly, and that the core support is at the perfect angle, and that the body mounts haven't shifted or sagged or been lifted....match the fan angle with the angle of the radiator and support, if that makes sense.
You don't have to believe either - just sketch it out in any CAD program,.






