Are you sure you're still getting the proper voltage signal when the key is in the START position? The computer needs that to work properly, which is why I thought of that when you mentioned the WSOD (white screen of death) on the module.
Are you having the FiTech control timing too, or just the fuel?
And what is your drain? How fast does the battery go dead? If within a few hours, it's usually either your alternator or just a tired battery.
Good luck.
Paul
Called tech. He said it might be that I have my red wire hooked to my solenoid and not directly to the battery terminal. He said the starter is drawing power the same time as the unit.
I'll try moving that red wire to the terminal.
And no, no timing control. I'm running the 400hp unit. I Read too many timing issues on here; I wanted to avoid any problems.
The drain isn't too bad. It will be slow to boot if I let sit for a few days. But overnight i don't think it's too bad. (Granted this was when it was carbed) so maybe the fitech needs more accurate power.
Also I already have the cold start up by 10. I might adjust the initial prime squirt. But according to fitech. That's a universal adjustment. And can't be set for cold or warm. So it will always shoot more regardless of temp.
I'll report back with my findings. Thanks guys
Sent from my iPhone using Tapatalk











