Double checked for exhaust leaks this afternoon, as far as I can tell leaks are not causing the sound. This weekend or next I'll probably pull the engine to inspect the flex plate and bottom end unless someone has a better or different suggestion
while the sound it there carefully disconnect on spark plug wire at a time and reconnect see if the pitch changes. if you find a suspect hole then you can pull the valve cover and start the engine you then can use a long pipe on the rocker arm to hear which is clicking. I have a cut out old valve cover to help with this type of work.
Carefully is right!!
Don't use insulated pliers with a rag thinking that 55,000 volts with a flipping half amp spark aint gonna knock ya on your butt or stop your heart...cause it can. So buy the proper tool because ya only get one chance right? I don't know if you're running pts or EDIS but new ignition systems aren't like the old ones that just seem to zap your funny bone for a bit.
I have done this check, like most of us, dozens of times isolating lifter or valve train noise.
I thought you'd already done this??
put a sounding rod on the timing cover and listen for timing chain noise. use a sounding rod on each exhaust port on the manifold.
Pretty sure it was mentioned early on in this discussion, but at this point with all the leaks accounted for and much of the valvetrain tweaked and/or fixed, any chance that it could be noisy fuel injectors? Most of them make a lot of noise.
Of course, if it's carbureted then it's just the carburetor crickets!![]()
Check exaust clamps and brackets (especially near the front of the vehicle). I have had some loosen up over time that seemed like valve train noise.






