• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Temp Sender Issues Solved

chuddy

Full Member
Joined
Sep 28, 2020
Messages
347
Like many folks, I've been struggling trying to find the correct temp sender for the 289 in my 66 Bronco. My gauge consistently read around 225 degrees, when it was actually running at 190. I tested the following senders with no change:

Napa TS6628
Napa TS6153
Standard TS24

I then discovered that our temp gauges run 10ohm-73ohm, so I found a sender that is designed for that range, WVE 1T1116. I installed that and it works absolutely perfectly. Figure I could save some time for people searching for a solution.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Thanks for the info. And the testing!
I didn’t really know there was a consistent problem with the temp senders, though modern parts are often a problem right out of the box.
Never heard of WVE. Got a link to any specific information on that company and sending unit?
 
OP
OP
C

chuddy

Full Member
Joined
Sep 28, 2020
Messages
347
Thanks for the info. And the testing!
I didn’t really know there was a consistent problem with the temp senders, though modern parts are often a problem right out of the box.
Never heard of WVE. Got a link to any specific information on that company and sending unit?
It's a pretty popular brand on Rockauto, guessing they just rebrand other OEM's parts and sell it cheaper. I got mine on Amazon: https://www.amazon.com/dp/B07DVMM9TZ/?tag=classicbroncos-20

If you search on CB about temp sender issues, you'll see a ton of discussion about it.
 

Muddy

New Member
Joined
Aug 28, 2011
Messages
38
Loc.
Georgia
It's a pretty popular brand on Rockauto, guessing they just rebrand other OEM's parts and sell it cheaper. I got mine on Amazon: https://www.amazon.com/dp/B07DVMM9TZ/?tag=classicbroncos-20

If you search on CB about temp sender issues, you'll see a ton of discussion about it.
Thanks for posting this. I have been on the same quest but hadn’t got as far as you. I just ordered this and look forward to having an accurate temp reading
 

Oldtimer

Contributor
Jr. Member with Sr. moments
Joined
Feb 4, 2005
Messages
1,802
Loc.
Sunnyvale, CA
. . . so I found a sender that is designed for that range, WVE 1T1116. I installed that and it works absolutely perfectly. Figure I could save some time for people searching for a solution.

It may work with the temp gage, but is not quite correct for the harness connection.

The threaded stud is #8 bolt and it needs to be #10 bolt for factory 90° push on connector.
You might try Dennis Carpenter C6DZ-10884-B.

TEMP SENSOR.jpg
 
Top