Epps1983
New Member
Just received a timing light and vacuum gauge, plugged everything off and hooked up to full manifold and was getting a steady reading of about 13 1/2 to 14. I knew that was kind of low but not knowing what engine work was done at the time of rebuild I went ahead.
Hooked the timing light up and she was set at 10 deg ATDC, loosened the dist and set it at 10 deg BTDC where the builder had a chalk mark. (Vacuum adv is still disconnected). After making the timing adjustment my vacuum increased to a steady reading of about 17, after adjusting the mix screws I brought it up to 18. I lowered the curb idle back down to 650 RPM's and checked my total advance at 3000 RPM's and found it to be 30 degrees. Is that enough?????
Also once I hooked the advance back up to the ported source the timing at idle stayed at 10 deg BTDC, shouldnt it be more advanced than that with vaccum attached? Also at about 2000 RPM the timing advanced to around 40 degs.
Can someone help me out here and help me make sense of this
Cheers,
Shawn
Hooked the timing light up and she was set at 10 deg ATDC, loosened the dist and set it at 10 deg BTDC where the builder had a chalk mark. (Vacuum adv is still disconnected). After making the timing adjustment my vacuum increased to a steady reading of about 17, after adjusting the mix screws I brought it up to 18. I lowered the curb idle back down to 650 RPM's and checked my total advance at 3000 RPM's and found it to be 30 degrees. Is that enough?????
Also once I hooked the advance back up to the ported source the timing at idle stayed at 10 deg BTDC, shouldnt it be more advanced than that with vaccum attached? Also at about 2000 RPM the timing advanced to around 40 degs.
Can someone help me out here and help me make sense of this
Cheers,
Shawn











