Wiring help needed

[burntfish]

I am getting close to installing the new engine and wire it up. I narrowed the front 14" and am running all new wires myself in the engine bay. I need some info on what stays in the Bronco and what stays on the floor. I'm putting in a 97 gt40p engine, c4, RJM harness and batteries under pass seat.

I know i need to keep the wires to the front lights 2, 3, 11, 12, 13 and 977

I know I need to keep 16, 31, and 39 to go to the RJM harness.
I assume I need to keep 32 and 262 for the starter or does it change with the explorer setup.
What else am I missing

 

[Steve83]

If you're running all new wires, then just run them to whatever needs wires: lights, horn, winch, alternator, starter relay... If you get the complete Explorer harness, you can use it and have more stuff: RKE, battery saver, PL, PW, PM...

. . .