No issues hitting the fan ducts and knocking the clamps off?Mine had the opening for a single din radio, just had to file it a little bit and the cage slid right in
View attachment 947946

Nice! Stripes look great!Got the suspension 90% done and drove out under it's own power. Still need to do the swaybars and start doing some shake down drives. View attachment 948189
It was built on 9/23/66Coming right along!
What month was your 67 built in? Maybe we can track it as a late model change between the early and late mirror spacing.

I used a harbor freight furniture dolley and some 4x4 blocks screwed together with a V notch to wheel mine in and out recently.Now that I got my new springs installed, I’m pulling the axle out. It’s gonna get new C-bushings, bearings, ball joints, and a fresh coat of paint. Then I’ll put those new springs back in again.
I just gotta fit a few more jackstands under there.![]()
![]()
I used a harbor freight furniture dolley and some 4x4 blocks screwed together with a V notch to wheel mine in and out recently.
View attachment 948260
"Simplicity is the ultimate sophistication." - Leonardo da VinciJust sat in the garage with a cold one admiring the simplicity of it all.
View attachment 948251
Me too. Upgraded to 31 spline.Got my new WH axles installed with SS hard brake lines and new shoes. I dreaded doing the rear brakes but if you figure out every way NOT to do them first... by the fifth time, you get it. The driveshaft had a broken center yoke so that was replaced along with all the u-joints and then a balance. All good now. View attachment 948259






