Search results

I lost a header bolt while I was wheeling the other day. If somebody can tell me what the bolt size is I sure would appreciate it. Don't know if it is standard or if it matters what type of headers I have. thanks

Cage arms would be great!

Thanks guys. I think I am going to get the protools or jd. They both look like great products. thanks matt

thanks matt

here is the bender I was looking at http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=44094 Thanks for the replies matt

I was at harbor feight today and saw they had a tube bender and notcher. The bender was only 100 bucks and the notcher attached to a drill press and was only 50 bucks. Are these any good for the occasional use? I want to try and build some rocker protection and quarter panel protection for...

I run wildhorses 3.5inch suspension with a 2" body lift with 36"tires that fit pretty good. Body lift lowers the center of gravity ober suspension lift. matt

Ddrass, they also wanted to me to write a statement that it would only be driven to and from parades or shows and it would never be taken off-road. I obviously chose to go a different route through my own insurance agent. matt

Haggerty has limited mileage. When I called them they wanted to only give me like 1,000 miles a year. I went through my all-state agent and he found me coverage for my bronco that states $15,000 on policy. matt

Thanks. One of my friends said to put an aspirin in the thermostat to stick it open for a few minutes to not get an air bubble. Has anybody ever done this? matt

I took my thermostat out this morning and did not pay attention to the direction it was in. Does the brown button end go towards the motor or does the other end with the cone shape go towards the motor? Sorry for such a stupid question. matt

Randy is an awsome guy and like said above does quite a bit with the AZ bronco club. matt

Excellent, I know you will be much happier with a softer suspension. Good thing you caught the order that would of sucked to have to pay to ship the springs and coils back. matt

If you did not get the superflex stuff from Jeff's I would cancel the order based on what I have read on this board. I have no personal experience with Jeff's, but had a very stiff KbarS lift prior to my new WH's lift. matt

Never thought about welding on the floor and a draft, but that does make sense. thanks for all the help guys. matt

Okay, my welds looked a little off and I had it at about 35, so I will lower it and see what happens. matt

Just hooked my new miller 210 and was wondering what I should have the gas setting at. I am running argon mix. I have never welded with gas, but have done quite a bit with flux core wire. Any help would be appreciated. thanks matt

Okay, I am not at home the rest of the evening, but I will pull the thermostat tomorow night and check it. Thanks for all the help so far 72 matt

Rent an H3 and tear the crap out of it and take it back to avis. matt

Okay, I started it tonight and let idle for about 5 minutes and it went up to about 220 it would have kept climbing, but I drove it around the block to cool it down and shut it off. I am not a mechanic, but I would think that I am not getting enough air through the radiator at idle. matt