1buckeyefan1
Sr. Member
- Joined
- Sep 21, 2017
- Messages
- 641
So I finally got my engine and Trans in. A little surprised at how much higher it sits vs the stock c4...but I suspect it's because the bc cross member sits low for the exhaust to route above. The bc bronco cross member isn't quick bolt-in, looks like I need to drill another set of holes in it. I knew I had to make a spacer for the 4r70w awd tailpiece, but was told that it should only be an inch or so.
So I've checked other threads and they've leveled the Trans pan.. however it sort of feels like I should level based on the lower intake? At least that appears to be "more level" to the eye. that and it makes the 4r70w mounting flange level too.
If I level to the intake, i have about a 4" gap to make up. The engine "looks" level, but the trans pan is not.
If I level to the trans pan, I have a 1.5" gap to make up and I can *barely* catch the tail end of the mounting holes. This seems right, but odd that the 4r70w mounting flange is not parallel to the crossmember, which leaves the trans mounting pad not quite square. But if I mount with the trans pan level, it seems that it has to be this way?
So I've checked other threads and they've leveled the Trans pan.. however it sort of feels like I should level based on the lower intake? At least that appears to be "more level" to the eye. that and it makes the 4r70w mounting flange level too.
If I level to the intake, i have about a 4" gap to make up. The engine "looks" level, but the trans pan is not.
If I level to the trans pan, I have a 1.5" gap to make up and I can *barely* catch the tail end of the mounting holes. This seems right, but odd that the 4r70w mounting flange is not parallel to the crossmember, which leaves the trans mounting pad not quite square. But if I mount with the trans pan level, it seems that it has to be this way?
Attachments
Last edited:












