Windsor flywheel bolt pattern dimensions

[Digger556]

I need accurate dimensions of the crankshaft to flywheel bolt pattern. Is there a print out there with this information before I start tearing something apart?

 

[DirtDonk]

Dang, I've seen a nice one comparing various engines online somewhere. But I bet I didn't save it at the time!
Typical...

I'll dig around though, just in case.

Paul

 

[Broncobowsher]

Might ask Eagle or Scat. I bet they would be willing to tell you what the bolt spacing is on the cranks they make.

I do know it is NOT symmetrical. The bolts are spaced oddly so it only goes on one way, so the balance is in the right spot.

 

[Digger556]

I found this on the GT40s forum:

6 holes to suit 7/16" bolts on 3" PCD ---One hole at 64 deg (ie 60,60,60,60,56,64 ) approx. opp the counterweight looking from the clutch side of the flywheel.

Maybe someone can confirm

 

[Digger556]

I found this on the GT40s forum:




Maybe someone can confirm

FYI - This is confirmed now.