I am getting no power through the sending unit wire. Checked it with a test light.
Just did the wire test by grounding test lite to the frame and I am getting a blinking lite by probing the wire from the gauge.
That's two different results from the same wire, so could indicate either that your test methods are not consistent, or there is something wrong with the wire and/or connector.
What did you use to test the first time when you had no power coming through the wire/connector?
Maybe try it again and see if moving the wires around while you're testing results in erratic behavior of the reading.
Oil, amp and other gauges working. Not sure why it did not cause gauge to move earlier when I crossed connected the two terminals at the plug.
This tells me my new sending unit is bad?
Maybe...
As mentioned you can't use the ammeter as a guide in this case, since it's independent of the other gauges. But the Oil and Water gauges working tells you that the power supply to the gauges (the IVR, or instrument voltage regulator) is sending a signal through the gauges and out to the sending units.
But because these are different items, you could still have a bad fuel gauge (but it worked before, right?), a bad switch (with a single tank you do not have this switch), a bad wire between the gauge and sender (but the flashing light says that you at least have it sometimes), or a bad connector and/or bad ground connection.
The sending unit is the last thing to consider at this point because you jumpered the two contacts in the connector together and got nothing. This eliminates the sending unit as the only culprit, and opens up some more.
If you're getting a consistent signal/flash at the connector, keep trying to ground that wire out to see what your gauge does.
Instead of using the test light, and instead of jumpering the two connectors together, do as suggested by someone i think and connect that contact directly to a ground point on the frame, or body. Turn the key back to ON, or ACC and see if the gauge reads full now.
And follow the ground wire to it's termination point. Is it on the body, or the frame?
Because this does use a chassis ground farther back away from the battery than most other stuff, it never hurts to verify that you still have a good body ground like they originally came with from the factory.
At the battery negative terminal, how many wires/cables do you see? If only the one large ground cable down to the engine, you need to add another one to the body somewhere. And while you're at it you should add one from the back of the engine over to the firewall. This is a ground connection that Ford and most other manufacturers have used for decades for an improved setup. Unfortunately Early Broncos were never so lucky. So do yourself a favor and add one if it has not been added already.
If it's a later '77 maybe you even have one. I've never seen one even on '77's, but there are several members here that own '77 models that do have a ground strap at the back of the engine. So who knows? Maybe Ford got diligent and cut the EB a break towards the end of the run.
Paul