What have you done to your Bronco today?

[miikee73]

Got a Thule basket the other day,didn't like the mounting,too high. I found some thinwall conduit that was exactly the right fit for my crossbars to slide thru,so I cut 4 peices and welded them to the basket. Nice clean install.........Mikee likee!

 

[73stallion]

finally took my 30 ton crane hook off the hitch, think 3 years is long enuf to run it.

 

[orangecrush4u]

Cleaned out my garage with 7 months worth of crap and tried to see if the bronco would make it cause of the new lift and it went in with zero clearance, wheeew;D

 

[Fredly1]

Aligned the doors and replaced tranny filter and leaky gasket

 

[Steve83]

Dumped a few pounds of dirt out of the frame, along with a nut wrapped around the end of a sheared bolt, a really cheap 12mm wrench, and 2 wasps' nests.

 

[broncoitis]

Reinstalled the steering column and listened to the sweet sound of it running! ;D

 

[sprdv1]

Checked fluids, tire pressure, ready for kc meet/greet

 

[cvbfireman]

well what have i done to my bronco today??? hm...... ive looked at it every day for a month with a frown because theres no motor in it yet....

but it is awesome when my brother or my mom ask if they can take it out for the weekend.... i say sure go right ahead then they go out and remember theres no engine haha

 

[bronco t]

I like mine topless

Installed new Bestop for summer cruising and parked the hard top until winter. Took her out for a beach run, and enjoyed the warm day in San Diego. Yes... Life's good

 

[cracker]

Repaired the Moab damage finally. Replaced the Wrap Trap bushing and found a broken U-bolt on the rear driveshaft. Re-torqued the rear yoke on the 9" and greased everything again... finally, blew out the dust and moths from inside the cab and went for a cruise...

 

[powersfab]

pushed it out of the grage and in to the tall grass

 

[orangecrush4u]

drove it to get exhaust but I got the shaft and left!!!!!

 

[Skiddy]

drove it to get exhaust but I got the shaft and left!!!!!

everyone needs a spare shaft right;D

 

[orangecrush4u]

everyone needs a spare shaft right;D

yea but not that kinda shaft

 

[76MaBronco]

mine's getting picked up tonight for the exhaust...after also getting the shaft at a local garage...Oh well, this way will be cheaper and done by a fellow Bronco owner...

 

[72_EB]

Out driving on the surface of the sun again today.

 

[Z Bronco]

Drove my bronco and decided to wait till my son gets here for the summer to start the teardown and EFI conversion.

 

[73stallion]

next show us a pic of you frying an egg on your hood!

 

[72_EB]

Will that harm my rattle can finish? I just felt the hood. It probably would today.

next show us a pic of you frying an egg on your hood!

 

[Fredly1]

Picked up a set of door locks and headlight switch from parts store